Installation | OutBraker2018-10-17T10:59:08+00:00

HOW TO INSTALL

Watch the simple installation process

› Step 0. Prepare Tools and OutBraker
› Step 1. Remove the Brake Hose
› Step 2. Install OutBraker
› Step 3. Cut the Hose / Remove the Compression Bolt
› Step 4. Join the Brake Hose to Banjo Kit
› Step 5. Air Bleeding and Oil Supplement

HOW TO BLEED DOUBLE SYSTEM?
Video instalación

INSTALLATION GUIDE

Follow each step to Install OutBraker

Step 0. Install Preparation

01. Prepare a OutBraker that fits your brake brand and the hose.

02. Tools: 8mm , 15mm Spanner, Allen Key, Hose Cutter, Bleed Kit

03. Cover the rotor with a clean cloth to prevent contamination.

Step 1. Remove the Brake Hose

01. Loosen the compression bolt using 8mm spanner.

02. Remove the brake hose from the lever body.

Step 2. Install OutBraker

01. Thread Outbraker into the lever body by hand first.

02.  Tighten hex using 15mm spanner(Torque 4-6N·m).

Step 3. Cut the Hose / Remove the Compression Bolt

01. Cut the brake hose about 1.5cm using a hose cutter.

02. Remove the compression bolt from the brake hose.

Install

Step 4. Join the Brake Hose to Banjo Kit

01. Pass the brake hose through the sleeve nut and the olive.

Install

02.  Join the Brake hose to the Insert until there is no gap between the hose and the banjo.

Install

03-1.  Tighten the Banjo Fixing Bolt using 4mm Hex wrench(Torque 4-6N·m)

Install

03-2.  Tighten the Sleeve Nut using 8mm spanner(Torque 7N·m)

Instalación

Step 5. Air Bleeding and Oil Supplement

Bleed Air using its proper Bleeding kit and Oil for the brake brand.

SERVICE DOCUMENTS

DOWNLOAD

EXPERT MANUAL

DOWNLOAD

SETTING CHART

DOWNLOAD